|
Quantity
|
Out of stock
|
||
|
|
|||
|
|
|||
The Jansen HMB-180 is a hydraulic cutter bar (hedge trimmer) on an extendable arm with a working width of 180 cm. It mounts on the Cat. I three-point hitch of a small or compact tractor from 20 HP and is driven by the PTO. It has its own hydraulic system, so it does not load the tractor’s hydraulics.
Uses and advantages
The arm (up to about 370 cm) reaches higher and hard-to-access spots along hedges, fences, paths and field edges. The bar trims hedges and shrubs quickly and cleanly; material up to 2.5 cm in diameter can be cut.
The hose set with the control valve and levers is long enough to be mounted in a convenient place on the tractor. The hydraulic oil tank holds 20 l and drive comes from a PTO pump at 540 rpm. The low weight also makes it usable with compact tractors.
Key specifications
- Working width 180 cm, boom length max. 370 cm
- Required tractor power: from 20 HP
- Cat. I three-point hitch, PTO 540 rpm
- Hydraulic oil: 20 l (HLP46 recommended)
- Weight 240 kg (260 kg with packaging), packaging 180 x 80 x 191 cm
Please note: delivery and start-up
- The machine is delivered in a steel frame, partially disassembled, and needs final assembly before first use.
- Allow about 2–3 hours for final assembly and commissioning. A German operating manual is included.
- Before the first start, fill the hydraulic system with about 20 l of HLP46 hydraulic oil.
- Do not run the cutter bar at excessive speed: this can damage the connecting rod. The manufacturer’s video shows the recommended working speed (from minute 2:03).
- On receipt, check that the shipment is complete, matches your order and shows no visible transport damage.
Similar equipment is in flail mowers and mowers and mulchers.


